Brick Controller II

I have been slowly studying the layout of the Brick Controller II, looking for subtle errors. I realized I will not have it ready to sell by Bricks by the Bay, I have decided to put more effort into review,

Here is the latest design in 3D.

Here is the top (red) and bottom (blue) layer without the ground fill.  The top layer is prominent. 

I am very close to generating the gerber files and sending it out to fabrication and assembly.

Store Offerings

One thing we have never written about is the online store. 

It can be found here https://store.mymakertools.com/

The store is where you can find all of our inventory that you would normally see at our shows.

Here is our low cost Brick power module.

https://store.mymakertools.com/products/usb-brick-power 

This is the Brick Controller I and it's power module.

https://store.mymakertools.com/products/usb-brick-power-rev-2 

https://store.mymakertools.com/products/brick 

We also have combinations kits where you can purchase different modules together at a discount.  It is a nice way to build up a tool kit for your development.

 

https://store.mymakertools.com/products/maker-pro-kit 

 

https://store.mymakertools.com/products/maker-expert-kit 

 

https://store.mymakertools.com/products/maker-ultimate-kit 

Finally we do take custom orders for our SoftWear line.  But please no large orders.  Remember that each one of these hand made with extra care.

  

https://store.mymakertools.com/products/shirt-with-brick-builder-motif