To move the doors as discussed previously, this entire module will need to be rebuilt. While I am add it, I decided to also redo the wiring as much as possible. So lets get started.
First I took lots of pictures of the module from all angles. Mostly I needed to make sure that I keep the dimensions the same and that all interface to other modules remain the same.
Then I started removing in the biggest chunks possible of the top structure.
Until this was left.
And this is the bottom side view.
While the blue base plate was a good solution at the time, it did not provide enough support. So I changed it to this.
While this design provides much better support, it is not the final version. I am still working on power distribution throughout the module. So I suspect this is going to change. This is made up of two 16 x 16 plates on the front of the module and then two more on the back. Then there are two 6 x 16 plates in the center. Unless I want to drill through these plates, some things will have to change.
No comments:
Post a Comment