Started cleaning up the PC software for the Brick Buddy line of controllers. One single software package will work for the entire line of Brick Buddys, at least as I see them today. The PC software will interrogate the attached device and determine what it is and then load the appropriate software options.
When the software first starts and when no recognizable device attached, then the control center window will show this:
At this point the user needs to connect a Brick Buddy device to the PC. Once the device is connected, the PC will begin to enumerate the device and determine it's identity. Once the identity is determined, the window on the PC will expand to show what device is connected, device status and what if any options are available. This is shown in the figure below.
This change should make it much easier for everyone to use the PC based software to program and control their individual Brick Buddy devices.
No comments:
Post a Comment