Another Curved Cliff - Part 5

 

Small aside here.  Power distribution on the other side of the display was improved as described in this post.  I needed to do this here also.  This is 20 gauge wire that runs another neither the bottom of each platform.  

This picture was taken before the change of where the angular sides would be as described in the previous post. 

Another view.

Here you can see the wiring in the final configuration.

A change from the previous implementation is shown here.  Previously the connection wire was soldered into the distribution PCB.  Now there is a connector.  I was worried after Brick Palooza that the connector end (not the soldered end) would break.  This way I can bring extra wires and if one breaks, just remove it  and put in a new one.