Another Curved Cliff - Part 2

The cliff base behind the module on the right is a straight forward cliff base.  Since the angular portion is on the other cliff base. 
 

Here is the cliff base with the floor supports.

Here are the two cliff bases in place.  It may be hard to see, but so far the angles are lining up.

Here the cliff base flooring is installed. The arrow points to where the wiring will come up from below.  by using the modified brick 1 x 2, with groove (p/n 4216), the groove will form a tunnel that the wire can transverse.

This shows the bottom of the cliff base and where the wire will exit.

This same 1 x 2 modified brick is used in the support wall.  There will have to be some playing with the rock face build and the wire.  Something similar to what I did on the other curved cliff as described in this post.  The wire will enter through the pin hole and this will power the LEDs on the first level.  The wire then comes back out the pin hole and will go to the second level and enter through another brick with pin hole to power the LEDs on the second level.