I have spent a lot of time trying to get the angles correct on this section. As I explained in this post, it took a while to understand which wedge plates were going to generate the same angle. the Following pictures show how this was done.
This shows the angle going back to the platform first floor from the cliff.
On the other side, the same thing.
Just a different view.
You have to check the angle constantly when using wedge plates, especially if they are different sizes.
These are the three wedge plates that I used. But there is a very specific pattern where these will line up correctly. Which can make it difficult to get the angle continuous.
This picture illustrates the problem. The left side arrangement is fairly straight forward. But the right side arrangement shows that one row of studs must be skipped for to maintain a continuous angle.
No comments:
Post a Comment